TorkCraft - Ball Rotary Burr

Features:

• The Tork Craft Rotary burr for cutting steel, stainless steel, cast iron, high alloy, and brass.
• For a smooth surface finish. Max operating speed is 65000RPM but the recommended starting speed is 40000RPM.
• For cutting stainless steel, steel, cast iron, high alloy & brass
• Tungsten carbide burrs are much harder than HSS (High Speed Steel) burrs and are used to cut harder materials. The burrs wear less and retain their hardness under higher temperatures.
• If the burrs are chipping, this could be due to the speed being too slow. It is ideal to start the burr off slow, increasing the speed as you go along. High speeds will prevent clogging in the flutes of your burrs.
• When using burrs, always try to keep the burr on the move. This will prevent the burr from jabbing and digging into your material causing roughness.
• As with all drill Bits and burrs, let the burr do the work and apply little pressure otherwise the cutting edges of the flutes will chip, reducing the life of the burr.

Specifications:

• Diameter: 6 mm Cutting Length: 5 mm Max
• Operating Speed: 65000RPM 
• For cutting stainless steel, steel, cast iron, high alloy & brass
  
• Smooth surface finish
• Max Operating speed: 65 000RPM
• Recommended Operating speed: 40 000RPM
• NOTE: The recommended starting speed is 40 000 RPM
• WARNING: Using any tool can be dangerous. Always select the right tool for the job. This tool can get hot after use.